The key to the safety of centrifuge is the safety of motor rotor
Centrifuge is a kind of new scientific and technological instrument and equipment in laboratory, which is also widely used. It can be used as a reference in many aspects when the centrifuge model is selected. Centrifuge is a kind of special instrument and equipment, and there are certain safety risks in the application. Therefore, it is particularly important to ensure the safety of mechanical equipment and users of centrifuge! The key to the safety of centrifuge is the safety of motor rotor.
Pay attention to the following aspects when purchasing centrifuges:
First, pay attention to the purchase of imported bearings.
Centrifuge is belongs to high-speed rotating chemical machinery equipment. High speed rotation requires good bearing. High quality and pure bearing can ensure the long-term normal operation of centrifuge, and its service life is up to 10 years.


Third, the centrifuge spindle bearing concentricity can be accurate, under all normal conditions, we do not pay much attention to concentricity, spindle bearing concentricity tends to be large, easy to form bearing heating.
Naturally, here we analyze the key reasons. There are also some reasons that users should be more careful.
Safety application regulations of centrifuge:
1、The model selection should be appropriate.
2、Centrifuges shall be used according to the specified scope, and centrifuges for general purposes shall not be used in places of inflammable and explosive substances and places with corrosion.
3、Operate according to the specified safety operation rules, and do not abnormal braking system, overload operation and speed limit operation.
4、The failure detection should be carried out immediately. The centrifuge with common failure should not be operated, and the invalid centrifuge should be damaged immediately.
5、Install, apply and maintain the centrifuge according to the provisions of the commodity manual. Do not change the parts of the centrifuge or increase the speed ratio of the centrifuge.
6、Establish the relative management system of centrifuge installation, application and maintenance and strictly abide by it to achieve the purpose of safety application.
The heating of the components of the centrifuge is normal, because the application consumes some kinetic energy, but if it is too hot, then pay attention to it, check whether there is a problem, and properly handle it, so that the centrifuge can be used very well. With the popularization of centrifuges, a large number of manufacturers and users pay attention to the product quality of centrifuges, which is also a very good cooperation between manufacturers and users, so that the effect of centrifuges can be completely revealed.